|
It has come to my
attention that some ProDAT tools sold over the last year are defective.
The problem is that the
drill bit is set into the handle at the wrong height (too high). The
result is that the delays are drilled deeper than expected and the delay times
are too short by as much as five seconds. This can be catastrophic!
The correct overall length to the tip of the drill bit is 1.675" (see
below).
Please check your
ProDAT. If you have a bad one, send the drill piece only (keep the base)
to:
Loki Research, LLC
5301 Tacony St, Box 210
Philadelphia, PA 19137
|